Huawei NetEngine40E Hardware Description page 39

HUAWEI NetEngine40E Universal ServiceRouter
Hardware Description
Interface Attributes
Table 2-12
Table 2-12 1000MBase-X-SFP interface attributes
Attribute
Connector type
Operation mode
Standard compliance
Cable specification
Table 2-13
Table 2-13 10Base-T/100Base-TX/1000Base-T-RJ45 interface attributes
Attribute
Connector type
Operation mode
Standard
compliance
Cable
specification
Table 2-14
Table 2-14 Console interface attributes
Attribute
Connector type
Operation mode
Electrical
attribute
Baud rate
Issue 01 (2012-09-30)
BITS2 provides two SMB ports, and the signal type can be set to 2Mbps/2Mhz/1PPS+RS232. When
signal is 2Mbps/2Mhz,CLK/1PPS is fixed as input and CLK/Serial is fixed as output. When signal is
1PPS+RS232, CLK/1PPS and CLK/Serial are bound together, CLK/1PPS signal type is 1PPS whereas
CLK/Serial signal type is RS232, and the setting of input/output apply to both SMB ports.
lists the 1000MBase-X-SFP interface attributes.
lists the attributes of the 10Base-T/100Base-TX/1000Base-T-RJ45 interfaces.
Description
RJ45
10M/100M/1000M auto-sensing interfaces, supporting half-duplex and
full-duplex modes
IEEE 802.3-2002
Category 5 unshielded twisted pair (UTP) cables recommended when
the interface rate is 10 Mbit/s or 100 Mbit/s; super category 5 Shielded
Twisted Pair (STP) cables recommended when the interface rate is
1000 Mbit/s
lists the console interface attributes.
Description
RJ45
Duplex Universal Asynchronous Receiver/Transmitter (UART)
RS-232
9600 bit/s (default value), which can be changed as required
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
SFP
1000M fiber
IEEE 802.3-2002
Single-mode or multi-mode fibers
2 NE40E-X16 Chassis Overview
25