Huawei NetEngine40E Hardware Description page 117

HUAWEI NetEngine40E Universal ServiceRouter
Hardware Description
Indicator/Butto
n
interface)
ACT indicator
(amber) (on
Ethernet
interfaces)
Table 4-10
Table 4-10 Interfaces on the MPU and their uses
Interface Name
MGMT-ETH
(10M/100M/1000M
Base-TX
auto-sensing)
Console interface
AUX interface
CLK interface
TOD interface
Interface Attributes
Table 4-11
Table 4-11 10Base-T/100Base-TX/1000Base-T-RJ45 interface attributes
Attribute
Connector type
Operation mode
Standard
compliance
Cable
specification
Issue 01 (2012-09-30)
Description
If the indicator is blinking, data is being transmitted.
If the indicator is off, no data is being transmitted.
describes the interfaces on the MPU and their uses.
Connector
Type
RJ45
RJ45
RJ45
RJ45
RJ45
lists the attributes of the 10Base-T/100Base-TX/1000Base-T-RJ45 interfaces.
Description
RJ45
10M/100M/1000M auto-sensing interfaces, supporting half-duplex and
full-duplex modes
IEEE 802.3-2002
Category 5 unshielded twisted pair (UTP) cables recommended when
the interface rate is 10 Mbit/s or 100 Mbit/s; super category 5 Shielded
Twisted Pair (STP) cables recommended when the interface rate is
1000 Mbit/s
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 NE40E-X3 Chassis Overview
Description
It connects to the NMS workstation and has LINK
and ACT indicators.
It connects to the console for on-site configuration
of the system.
It connects to the Modem for remote maintenance
through dialing.
External synchronous clock interface
External synchronous time interface
103