Huawei NetEngine40E Hardware Description page 299

HUAWEI NetEngine40E Universal ServiceRouter
Hardware Description
Panel
Figure
Line Processing Unit (LPUI-51).
Figure 6-69 Panel appearance of the 4-Port 10GBase LAN/WAN-SFP+ Integrated Line
Processing Unit (LPUI-51)
Table 6-173 Indicators on the panel of the 4-Port 10GBase LAN/WAN-SFP+ Integrated Line
Processing Unit (LPUI-51)
Component
OFL button
OFL indicator
(red)
RUN (green)
L/A
indicator(green)
Interface Attributes
Table 6-174
Line Processing Unit (LPUI-51).
Table 6-174 Interface attributes of the 4-Port 10GBase LAN/WAN-SFP+ Integrated Line
Processing Unit (LPUI-51)
Attributes
Connector type
Optical interface
attributes
Working mode
Frame format
Network protocol
Issue 01 (2012-09-30)
6-69shows the panel appearance of the 4-Port 10GBase LAN/WAN-SFP+ Integrated
Description
It is an OFL button. Before removing a board, press the OFL button.
Hold the button for five seconds till the OFL indicator is on. Then, the
board can be pulled out.
If the indicator is steady on, it indicates that you can remove the
board.
If the indicator blinks once every 2s (0.5 Hz), it indicates that the
system is running normally. If the indicator blinks twice every 1s (2
Hz), it indicates that the system is in the alarm state.
If the indicator is on, the link is Up. If the indicator is blinking, the
data is being read or written. If the indicator is off, the link is Down.
lists the interface attributes of the 4-Port 10GBase LAN/WAN-SFP+ Integrated
Description
LC/PC
Compliant with the selected SFP+ optical module.
Full-duplex
Ethernet_II, Ethernet_SAP, and Ethernet_SNAP
IP
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Table 6-173 describes the indicators on the panel.
6 Boards
285