Huawei NetEngine40E Hardware Description page 38

HUAWEI NetEngine40E Universal ServiceRouter
Hardware Description
Indicator/Button
CF OFL button
SFP LINK/ACT
indicator (green)
MGMT-ETH LINK
indicator (green) (on
Ethernet network
interfaces)
MGMT-ETH ACT
indicator (amber) (on
Ethernet interfaces)
Table 2-11
Table 2-11 Interfaces on the MPU and their uses
Interface Name
USB interface
CF card interface
CTL-ETH-SFP interface
(1000MBase-X)
MGMT-ETH interface
(10M/100M/1000M
Base-TX auto-sensing)
Console interface
AUX interface
CLK/TOD0
CLK/TOD1
CLK/1PPS
CLK/Serial
Issue 01 (2012-09-30)
Description
If you press the CF OFL button, all operations on the CF card
will be ended and the CF card will be powered off.
If the indicator is steady on, the link is normal.
If the indicator is blinking, data is being transmitted.
If the indicator is steady on, the link is normal.
If the indicator is off, the link is Down.
If the indicator is blinking, data is being transmitted.
If the indicator is off, no data is being transmitted.
describes the interfaces on the MPU and their uses.
Connector Type
USB
TYPE II
(compatible with
TYPE I)
SFP
RJ45
RJ45
RJ45
RJ45
SMB
SMB
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 NE40E-X16 Chassis Overview
Description
It is not used and reserved.
It is used to hold a CF card to store data
files as a massive storage device.
It is not used and reserved for the use
after capacity expansion.
It connects to the NMS workstation and
has LINK and ACT indicators.
It connects to the console for on-site
configuration of the system.
It connects to the Modem for remote
maintenance through dialing.
It is used to input or output 2-Mbit/s
clock signals, 2-MHz clock signals,
1pps+ASCII clock signals, or two
channels of DCLS clock signals.
It is used to input or output 2-Mbit/s
clock signals, 2-MHz clock signals, or 1
PPS signals.
It is used to input or output 2-Mbit/s
clock signals, 2-MHz clock signals, or
RS232 signals.
24