Huawei NetEngine40E Hardware Description page 232

HUAWEI NetEngine40E Universal ServiceRouter
Hardware Description
Figure 6-28 1-Port 100GBase-CFP Integrated Line Process Unit panel
Table 6-71
Process Unit panel.
Table 6-71 Description of the buttons and indicators on the 1-Port 100GBase-CFP Integrated Line
Process Unit panel
Indicator/Butto
n
OFL button
OFL indicator
(red)
RUN (green)
LINK/ACT
(green)
Interface Attributes
Table 6-72
Unit.
Table 6-72 Interface attributes of the 1-Port 100GBase-CFP Integrated Line Process Unit
Attribute
Connector type
Optical
interface
attributes
Working mode
Frame format
Network
protocol
Issue 01 (2012-09-30)
describes the buttons and indicators on the 1-Port 100GBase-CFP Integrated Line
Description
It is an OFL button. Before removing a board, press the OFL button.
Hold the button for six seconds till the OFL indicator is on. Then, the
board can be pulled out.
If the indicator is steady on, it indicates that you can remove the
board.
If the indicator blinks once every 2s (0.5 Hz), it indicates that the
system is running normally. Otherwise, it indicates that the board fails
to run normally.
If the indicator is steady on, it indicates that the link is normal. If the
indicator blinks, it indicates that data is being transmitted. If the
indicator is off, it indicates that the link is Down.
lists the interface attributes of the 1-Port 100GBase-CFP Integrated Line Process
Description
SC/LC
Compliant with the selected CFP optical module. (For the attributes of
CFP modules, see
Full-duplex
Ethernet_II, Ethernet_SAP, and Ethernet_SNAP
IP
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Table 6-73)
6 Boards
218