Huawei NetEngine40E Hardware Description page 333

HUAWEI NetEngine40E Universal ServiceRouter
Hardware Description
Figure 6-86 Appearance of the 2-Port 10GBase LAN/WAN-SFP+ + 32-Port
100/1000Base-X-SFP Integrated Line Processing Unit L
Panel
Figure
100/1000Base-X-SFP Integrated Line Processing Unit L.
on the panel.
Figure 6-87 Panel appearance of the 2-Port 10GBase LAN/WAN-SFP+ + 32-Port
100/1000Base-X-SFP Integrated Line Processing Unit L
Table 6-225 Indicators on the panel of the 2-Port 10GBase LAN/WAN-SFP+ + 32-Port
100/1000Base-X-SFP Integrated Line Processing Unit L
Component
OFL button
OFL indicator
(red)
RUN (green)
L/A
indicator(green)
Interface Attributes
Table 6-226
100/1000Base-X-SFP Integrated Line Processing Unit L.
Issue 01 (2012-09-30)
6-87shows the panel appearance of the 2-Port 10GBase LAN/WAN-SFP+ + 32-Port
Description
It is an OFL button. Before removing a board, press the OFL button.
Hold the button for five seconds till the OFL indicator is on. Then, the
board can be pulled out.
If the indicator is steady on, it indicates that you can remove the
board.
If the indicator blinks once every 2s (0.5 Hz), it indicates that the
system is running normally. If the indicator blinks twice every 1s (2
Hz), it indicates that the system is in the alarm state.
If the indicator is on, the link is Up. If the indicator is blinking, the
data is being read or written. If the indicator is off, the link is Down.
lists the interface attributes of the 2-Port 10GBase LAN/WAN-SFP+ + 32-Port
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Table 6-225 describes the indicators
6 Boards
319