10-Port 10Gbase Lan/Wan-Sfp+ Line Processing Unit S(Lpus-101) - Huawei NetEngine40E Hardware Description

Hide thumbs Also See for NetEngine40E:

Table of Contents

HUAWEI NetEngine40E Universal ServiceRouter

Hardware Description

6.11.3 10-Port 10GBase LAN/WAN-SFP+ Line Processing Unit

Unit S(LPUS-101). The ten ports can be configured to work in LAN or WAN mode, HQoS is

not supported on this board.

Figure 6-56 Appearance of the 10-Port 10GBase LAN/WAN-SFP+ Line Processing Unit S

Figure 6-57 Appearance of the 10-Port 10GBase LAN/WAN-SFP+ Line Processing Unit S

Table 6-144 Indicators on the panel of the 10-Port 10GBase LAN/WAN-SFP+ Line Processing

OFL indicator

Issue 01 (2012-09-30)

shows the appearance of the 10-Port 10GBase LAN/WAN-SFP+ Line Processing

lists the indicators on the panel.

It is an OFL button. Before removing a board, press the OFL button.

Hold the button for five seconds till the OFL indicator is on. Then, the

board can be pulled out.

If the indicator is steady on, it indicates that you can remove the

If the indicator blinks once every 2s (0.5 Hz), it indicates that the

system is running normally. If the indicator blinks twice every 1s (2

Hz), it indicates that the system is in the alarm state.

If the indicator is steady on, it indicates that the link is normal. If the

indicator blinks, it indicates that data is being transmitted. If the

indicator is off, it indicates that the link is Down.

Huawei Proprietary and Confidential