Huawei NetEngine40E Hardware Description page 149

HUAWEI NetEngine40E Universal ServiceRouter
Hardware Description
Component
CF ACT indicator
(red)
LINK indicator (green)
(on the Ethernet
interface)
ACT indicator
(yellow) (on the
Ethernet interface)
Interface Functions
Table 5-13
Table 5-13 Functions of the interfaces on the SRU
Interface Name
ETH0
(10M/100M/1000M
Base-TX
auto-sensing)
Console interface
AUX interface
CF interface
CLK-IN1
CLK-IN2
CLK-OUT1
CLK-OUT2
Table
Issue 01 (2012-09-30)
Description


NOTE
The CF card is not hot swappable.




lists the functions of the interfaces on the SRU.
Connector Type
RJ45
RJ45
RJ45
TYPE II standard
(TYPE I standard is
compatible)
SMB (Sub-miniature B)
SMB
5-14lists the functions of the interfaces on the SRU that supports the 1588v2 protocol.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
If the indicator is blinking, the data is being received or
transmitted.
If the indicator is off, no data is being received or transmitted.
If the indicator is on, the link is Up.
If the indicator is off, the link is Down.
If the indicator is off, no data is being received or transmitted.
If the indicator is blinking, the data is being received or
transmitted.
Description
Used to connect the system network
workstation. This interface has the LINK
and ACT indicators.
Used to connect the console for system
configuration.
Used to connect to the modem for
remote maintenance through dialing.
Used to save data files as a massive
storage device.
Used to receive the external clock signal
of 2.048 MHz or 2.048 Mbit/s.
Used to output the 2.048 MHz or 2.048
Mbit/s clock signal to the downstream
device.
5 NE40E-8 Chassis Overview
135