Huawei NetEngine40E Hardware Description page 695

Hide thumbs Also See for NetEngine40E:

Table of Contents

HUAWEI NetEngine40E Universal ServiceRouter

Hardware Description

The tab is closed

Precautions for receptacle contamination

Issue 01 (2012-09-30)

with another object, however, the optical module will be loosened or the optical signals

will be temporarily cut off.

When inserting the optical module, make sure that the tab is closed. (At this time, the

latch boss locks the optical module.) After the optical module is inserted, try pulling it

out to see if it is installed in position. If the optical module cannot be pulled out, it is

Clean tissues must be prepared for the deployment on site. You need to clean the optical

connector before inserting it in the receptacle. This protects the receptacle against the

contamination on the end surface of the optical connector.

Use at least three cleaning tissues. Wipe the end of an optical connector horizontally in one direction,

and then move the connector end to the unused part of the cleaning tissue to continue. Generally, one

cleaning tissue can be used once for cleaning an optical connector.

To prevent contamination, the optical module should be covered with either a dust cap or

an optical connector.

Cover an optical module with a dust cap

Cover an optical module with an optical connector

Huawei Proprietary and Confidential

The tab is open

D Optical Module