Table of Contents
Advertisement
Configure the Connect IT 16/48
Setting
CTS
DCD
6. Click Save or Apply.
Enable a Telnet connection on the serial port
You can enable a Telnet connection on the serial port.
1.
Log in
to manage the Connect IT.
2.
Access the Configuration > Serial
3. Expand the port that you want to configure.
4. Expand the Telnet connection section.
5. Configure the settings.
Setting
Enable
Port
6. Specify the addresses, interfaces, and firewall zones which are allowed to access the serial
port. Expand the Access control list.
Setting
IPv4 Addresses
IPv6 Addresses
Digi Connect IT® 16/48 User Guide
Description
Select the CTS option to monitor CTS changes on this port.
Select the DCD option to monitor DCD changes on this port.
screen.
Description
Select the Enable option to allow the serial port to be directly
accessed by a Telnet connection.
WARNING! This connection is not authenticated
or encrypted.
Specify the Telnet port for the service.
Minimum value: 1
Maximum value: 65535
Default: 2001
Description
Expand the IPv4 Addresses section to add IPv4 addresses or
networks from which this serial port can be accessed. Click
Add to add an address.
Expand the IPv6 Addresses section to add IPv6 addresses or
networks from which this serial port can be accessed. Click
Add to add an address.
Configure a serial port
28
Advertisement
Table of Contents
