Station No. Setting; Control Input Signals - Fuji Electric Faldic-a RYS-R Series User Manual

(4) Station No. setting

・Basic type (DI/DO position)
Station No. setting is not necessary.
・SX bus type (SX bus direct connection)
Specifies the station No. in the system definition of D300win. Use the amplifier as it is with the station
No. "0". (Use it as the system para. 96 setting at "0" as it is.)
Set just the same station No. to system para. 96 to make the fail-soft function of SX bus valid.
・T-link (T-link direct connection)
Set the T-link address to system para. 96.
8.2 Motor
Check the motor model type and rated output [kW].
Key operation
MODE MODE
MODE MODE
ESC ESC ESC ESC
SHIFT SHIFT
SHIFT SHIFT
ENT ENT ENT ENT
8.3 Basic type (DI/DO position)
The basic type amplifier operates according to the control input signals.

(1) Control input signals

In the monitor mode of the keypad panel, the control input signal on/off status can be checked.
The main circuit power input and control input/output power supply (+24 [V] DC) can be supplied.
CONT13 (forced stop) is an NC contact input.
Key operation
MODE MODE
MODE MODE
ESC ESC ESC ESC
MODE MODE MODE MODE
ESC ESC
ESC ESC
SHIFT SHIFT SHIFT SHIFT
ENT ENT
ENT ENT
Indication (example)
Indication (example)
Remark
The sequence is displayed.
By the ESC key, select the sub-mode.
By the ∧ key or ∨ key, select [
Pressing the ENT key for at least 1 [s] displays the motor model type.
GYC type ("C" of cubic) motor of 0.1 [kW] is displayed on the left example.
Remark
Example of test running mode display
The MODE key selects a mode.
Select the monitor mode.
By the ∧ key or ∨ key, select [
Holding down the ENT key for at least 1 [s] allows to check the input signal
on/off.
8-3
].
].
MHT260a (Engl.)