Test (Trial) Running Operation; Preparation; Main Circuit Power Input; Main Circuit Power Supply - Fuji Electric Faldic-a RYS-R Series User Manual

8. TEST (TRIAL) RUNNING OPERATION

8.1 Preparation

(1) Preparation
A test running is carried out upon connecting the amplifier and motor. For the wiring method, see 4. TERMINAL DIAGRAMS AND WIRING.
For the test running, the motor is not connected to the mechanical equipment system and, when the operation is normal, it is connected to
the mechanical equipment system.
(a) Main circuit power input
The amplifier power supply includes main circuit power input (L1, L2, L3) and control power input (L1C, L2C).
The amplifier can be operated even if the control power input terminal is not connected to the power supply.
(b) Main circuit power supply
Connect the motor power line to the (U, V, W,
change the motor rotational direction.
(c) Encoder wiring
Connect the encoder for the motor to CN2 on the amplifier using a specified cable.
(d) Control input/output wiring
Do not connect CN1 and CN3 of the amplifier, when the test running temporary.
(2) Power supply
Supply the main circuit power to the amplifier. If the status is as follows, the amplifier is operating properly.
■ LED indication
When power is supplied, the "CHARGE" LED under the keypad panel of amplifier is lit red.
■ 7-segment indication
Periods for all of five 7-segment digits light once simultaneously.
・Basic type (DI/DO position)
If the para.(*) are as set at factory, the sequence of sequence mode appears.
・SX bus (SX bus direct connection)
If the para. are as set at factory, the station number of sequence mode appears.
・T-link (T-link direct connection)
If the para. are as set at factory, the station number of sequence mode appears.
Remark : The "CHARGE" LED lights with either the main circuit power supply or control power supply on.
Depending on the system para. setting, ABS data lost [AL] or other alarms may occur but it is not abnormal.
(*) Para. : Parameter(s)
) terminals on the amplifier terminal block (board). Changing the phase sequence cannot
Period
8-1
FALDIC FALDIC FALDIC FALDIC
FALDIC FALDIC FALDIC FALDIC
RYS201S3-VVS RYS201S3-VVS RYS201S3-RPS RYS201S3-RPS RYS201S3-RPS RYS201S3-RPS RYS201S3-VVS RYS201S3-VVS
MODE MODE MODE MODE MODE MODE MODE MODE SHIFT SHIFT SHIFT SHIFT SHIFT SHIFT SHIFT SHIFT
ESC ESC ESC ESC ENT ENT ENT ENT
ESC ESC ESC ESC ENT ENT ENT ENT
CHARGE CHARGE CHARGE CHARGE
K80791234 K80791234 K80791234 K80791234 CHARGE CHARGE CHARGE CHARGE
K80791234 K80791234 K80791234 K80791234
L1 L1 L1 L1
L1 L1 L1 L1
L2 L2 L2 L2 L2 L2 L2 L2
L3 L3 L3 L3
L3 L3 L3 L3
DB DB DB DB DB DB DB DB
P1 P1 P1 P1 P1 P1 P1 P1
P+ P+ P+ P+ P+ P+ P+ P+
N N N N N N N N
U U U U U U U U
V V V V V V V V
W W W W W W W W
MHT260a (Engl.)