Output Signal; Load Inertia Ratio - Fuji Electric Faldic-a RYS-R Series User Manual

(13) Output signal

Displays whether the control output signals from the amplifier are turned on or off. If signals are turned on, corresponding LEDs are lit.
ENT (1 [s] or more)
Pressing the MODE key holding down the
SHIFT key interchanges the H side and L side.
Note : Depending on the amplifier type, the number of control output signals changes.

(14) Load inertia ratio

Displays the load inertia ratio recognized by the amplifier regardless of the tuning method (basic para. 31).
(Moment of inertia recognized by amplifier)
(Load inertia ratio)＝
ENT (1 [s] or more )
Displays the magnification (in 0.1 step) of the moment of inertia of the motor.
ESC
(Moment of inertia of motor)
EST
[OUT16］ ・・・・・・・・・[OUT10]
[OUT8]・・・・・・・・・・・[OUT2] [OUT1]
[OUT32]・・・・・・・・・・・・・・・・・・[OUT26] [OUT25]
[OUT24]・・・・・・・・・・・・・・・[OUT18] [OUT17]
7-13
[OUT9]
MHT260a (Engl.)