Designating Ports In The Command Line Interface; Figure 17: Port Parameter In The Command Line Interface; Figure 18: Slot Numbers For Port Numbering On Stand-Alone Switches; Table 14: Port Parameter Format - Allied Telesis AT-x950-28XSQ Installation Manual

Designating Ports in the Command Line Interface

Slot Number 1 for
XEM2 Line Card:
portn.1.n
The individual ports on the switch are identified with the PORT parameter
in the command line interface of the AlliedWare Plus management
software. The format of the parameter is shown in Figure 17.
Switch ID Number
Figure 17. PORT Parameter in the Command Line Interface
The three parts of the PORT parameter are described in Table 14.
Table 14. PORT Parameter Format
Number
Switch ID Number
Slot Number
Port Number
Figure 18 identifies the slot numbers for base ports and line card ports.
Figure 18. Slot Numbers for Port Numbering on Stand-alone Switches
AT-x950-28XSQ Switch and VCStack Installation Guide
n.n.n
port
Slot Number
Port Number
Description
Identifies the switch's ID number, which
identifies the switch in the stack. Each
switch has a unique ID number. Switches
display their ID numbers on the Switch ID
LEDs on the front panels.
Identifies whether ports are base ports or
ports on an XEM2 Line Card. Slot number
0 indicates base ports and slot number 1
indicates ports on a line card. Refer to
Figure 18.
Identifies a port number.
Slot Number 0 for
Base Ports:
portn.0.n
45