Designating Ports In The Command Line Interface; Figure 19: Port Parameter In The Command Line Interface; Figure 20: Slot Numbers For Port Numbering; Table 19: Port Parameter Format - Allied Telesis AlliedWare Plus x950 Series Installation Manual

Chapter 1: Overview

Designating Ports in the Command Line Interface

Slot Number 1 for
XEM2 Line Card:
portn.1.n
50
The individual ports on the switch are identified with the PORT parameter
in the command line interface of the AlliedWare Plus management
software. The format of the parameter is shown in Figure 19.
Switch ID Number
Figure 19. PORT Parameter in the Command Line Interface
The three parts of the PORT parameter are described in Table 19.
Table 19. PORT Parameter Format
Number
Switch ID Number
Slot Number
Port Number
Figure 20 identifies the slot numbers for base ports and line card ports.
Figure 20. Slot Numbers for Port Numbering
n.n.n
port
Slot Number
Port Number
Description
Identifies the switch's unique ID number in
the stack. When the VCStack feature is
enabled, switches display their ID numbers
on the Switch ID LEDs on the front panels.
Identifies whether ports are base ports or
ports on an XEM2 Line Card. Slot number
0 indicates base ports and slot number 1
indicates ports on a line card. Refer to
Figure 20.
Identifies a port number.
Slot Number 0 for
Base Ports:
portn.0.n