Mitsubishi Electric 800 Series Instruction Manual page 711

REVISIONS
Print Date *Manual Number
Nov. 2014 IB(NA)-0600563ENG-A
Jan. 2015 IB(NA)-0600563ENG-B
May 2015 IB(NA)-0600563ENG-C
Mar. 2019 IB(NA)-0600563ENG-D
For Maximum Safety
• Mitsubishi Electric inverters are not designed or manufactured to be used in equipment or systems in situations
that can affect or endanger human life.
• When considering this product for operation in special applications such as machinery or systems used in
passenger transportation, medical, aerospace, atomic power, electric power, or submarine repeating
applications, please contact your nearest Mitsubishi Electric sales representative.
• Although this product was manufactured under conditions of strict quality control, you are strongly advised to
install safety devices to prevent serious accidents when it is used in facilities where breakdowns of the product
are likely to cause a serious accident.
Please do not use this product for loads other than three-phase induction motors.
710
IB(NA)-0600563ENG-D
*The manual number is given on the bottom left of the back cover.
First edition
Addition
• FR-A860-00027 to 00170
Modification
• Location change of earth (ground) terminals for the FR-A860-00027 to
00170
Addition
• Start count monitor (Pr.1410, Pr.411)
• Excitation current low-speed scaling factor (Pr.14 = "12 to 15", Pr.85, Pr.86,
Pr.565, Pr.566, Pr.617)
• Backup/restore function
• Input signals (CLRN, JOGF, JOGR)
• Output signal (SAFE)
• Simple position control by point table (The home position information is
retained at servo-OFF.) (Pr.419 = "10")
• MODBUS RTU communication stop bit length selection
• Continuous operation at communication error (Pr.502 = "4")
• Load characteristics fault detection (Pr.1480 to Pr.1492)
• Droop control using the per-unit speed control reference frequency (Pr.288
(Pr.681) = "20 to 22")
• Torque current command limit (Pr.801, Pr.803 = "2")
• PID manipulated amount: 0 to 100% (Pr.1015 = "2, 12")
• Pr.1348 P/PI control switchover frequency
• Pr.1349 Emergency stop operation selection
• Operation selection at a communication error (Pr.502 = "11, 12")
• Multi-revolution counter monitoring
Modification
• Pr.275 setting range: 0 to 300%
• Reset selection / disconnected PU detection / PU stop selection (Pr.75 =
"1000 to 1003, 1014 to 1017, 1100 to 1103, 1114 to 1117")
• External fault input signal (Pr.178 to Pr.189 = "32")
• Error reset operation selection at inverter fault (Pr.349 = "100, 101")
• PLC function (Pr.414 = "11, 12", Pr.675)
• Pulse monitor selection (Pr.430 = "2000 to 2005, 2012, 2013, 2100 to 2105,
2112, 2113, 3000 to 3005, 3012, 3013, 3100 to 3105, 3112, 3113")
Revision