D) Operation Command And Frequency Command - Mitsubishi Electric 800 Series Instruction Manual

(D) Operation command and frequency command

5.9
(D) Operation command and frequency
command
Purpose
To select the operation mode
To start up in Network operation
mode at power-ON
To select the command source
during communication operation
To prevent motor from rotating
reversely
To change the setting resolution
of speed
To change the setting resolution
of the torque limit
To set the frequency by pulse
train input
To perform JOG operation
To control frequency with
combinations of terminals
To select torque command
method during torque control
290
PARAMETERS
Operation mode selection
Communication startup
mode selection
Operation and speed
command sources during
communication operation,
command source selection
Reverse rotation prevention
selection
Set resolution switchover
Set resolution switchover
Pulse train input
JOG operation
Multi-speed operation
Torque command source
selection
Parameter to set
P.D000
P.D000, P.D001
P.D010 to P.D013
P.D020
P.D030
P.D030
P.D100, P.D101,
P.D110, P.D111
P.D200, P.F002
P.D300 to P.D315
P.D120, P.D121,
P.D400 to P.D402
Refer to
page
Pr.79 291
Pr.79, Pr.340 300
Pr.338, Pr.339,
301
Pr.550, Pr.551
Pr.78 308
Pr.811 345
Pr.811 345
Pr.291,
308
Pr.384 to Pr.386
Pr.15, Pr.16 312
Pr.28,
Pr.4 to Pr.6,
314
Pr.24 to Pr.27,
Pr.232 to Pr.239
Pr.432, Pr.433,
190
Pr.804 to Pr.806