Mitsubishi Electric 800 Series Instruction Manual page 350

Increment
Monitor item
and unit
Orientation
1
status

Actual operation
1 h
time

Motor load factor 0.1%
0.01 kWh/
Cumulative power
0.1 kWh

Position command 1
Position command
1
(upper digits)
Current position 1
Current position
1
(upper digits)
Droop pulse 1
Droop pulse (upper
1
digits)
Torque command 0.1%
Torque current
0.1%
command
0.01 kW/0.1
Motor output
kW

Feedback pulse —

Torque monitor
(power driving/
0.1%
regenerative driving
polarity switching)
Trace status 1
SSCNET III
communication 1
status

Pr. setting RS-485
22 H16
23 H17
24 H18
25 H19
26 H1A
27 H1B
28 H1C
29 H1D
30 H1E
31 H1F
32 H20
33 H21
34 H22
35 H23
36 H24
38 H26
39 H27
(M) Monitor display and monitor output signal
Negative
MODBUS
indication
RTU
(-)

Displays values only when orientation
control is enabled. (Displays the
40222 voltage monitor when a vector control
compatible option is not connected.)
(Refer to
Displays the cumulative time since
the inverter began running.
The number of times the monitor
40223 value exceeded 65535 h can be
checked with Pr.564
This can be cleared with Pr.171.
(Refer to
Displays the output current value as a
percentage, considering the inverter
rated current value as 100%.
40224
Monitor value = output current
monitor value / inverter rated current
 100 [%]
Displays the cumulative energy
based on the output power monitor.
40225
This can be cleared with Pr.170.
(Refer to
40226 
Displays the position command
(decimal) before the electronic gear is
40227 
set.
40228  Displays the value of the position
feedback pulse after converting it into
the number of pulses before the
40229 
electronic gear is set.
40230 
Displays the droop pulse before the
electronic gear.
40231

Displays the torque command value
40232  obtained from the vector control
results.
Displays the commanded current for
40233 
the torque.
Multiplies the output torque at that
time with the motor speed, and
40234
displays the machine output for the
motor shaft end.
Display the number of pulses fed
back from the encoder during one
sampling (also displays during stop).
(Displays the voltage monitor when a
vector control compatible option is not
connected.)
40235
The sampling time varies with the
Pr.369 Number of encoder pulses
setting.
1050 or less: 1 s
1051 to 2100: 0.5 s
2101 to 4096: 0.25 s
Displays the same value as that of
the motor torque. Displays plus value
40236 
for power driving and negative value
for regenerative driving.
Displays the trace status. (Refer to
40238
page
The SSCNET III communication
status between the inverter and the
40239 controller is displayed.
The output voltage is displayed when
the FR-A8NS is not installed.
Description
page 473)
page 354)
page 353.)



533).
349
PARAMETERS
5
GROUP
M