Mitsubishi Electric 800 Series Instruction Manual page 290

(F) Setting of acceleration/deceleration time and acceleration/deceleration pattern
Lift operation adjustment (Pr.61, Pr.64)
• The application range can be expanded by setting the parameters for adjustment of Pr.61 and Pr.64.
Pr. Name
61
Reference current
Starting
64
frequency for
elevator mode

The setting range for the FR-A860-01080 or lower.

The setting range for the FR-A860-01440 or higher.
NOTE
• Even if the lift operation has been selected, inputting the JOG signal (Jog operation), RT signal (second function selection) or
X9 signal (third function selection) during an inverter stop will disable the automatic acceleration/deceleration and give priority
to JOG operation, second function selection or third function selection. Note that during operation, an input of JOG and RT
signal does not have any influence even when the automatic acceleration/deceleration is enabled.
• Even if Pr.61 and Pr.64 are set, changing Pr.292 automatically resets to the initial setting (9999). Set Pr.61 and Pr.64 after
setting Pr.292.
Parameters referred to ???????
Pr.0 Torque boost page 589
Pr.13 Starting frequency page 283
Pr.14 Load pattern selection page 593
Pr.19 Base frequency voltage
Pr.2 Stall prevention operation level
Pr.570 Multiple rating setting
Setting range
0 to 500 A

0 to 3600 A

9999 (initial value)
0 to 10 Hz
9999 (initial value)
page 591
page 332
page 249
Description
Set the rated motor current value when the motor capacity and inverter
capacity differ, etc. Set the reference current (A) of the stall prevention
operation level.
The inverter rated output current value is the reference.
Set the starting frequency for the lift operation.
Starting frequency is 2 Hz.
289
PARAMETERS
5
GROUP
F