Setting The Operating Mode; Setting The Mode Of The Electrical Channel (Ch1) - Siemens SIMATIC NET Operating Instructions Manual

4.2

Setting the operating mode

4.2.1

Setting the mode of the electrical channel (CH1)

Note
The following information applies only to the default setting of S7 (S7 = 0); in other words,
compatibility turned off.
With the DIL switch S0, you set the mode of the electrical channel CH1.
Mode "electrical channel with segment monitoring"
Mode "electrical channel without segment monitoring"
Note
Set this mode only in the star segment of a star topology.
Optical link module
Operating Instructions, 01/2020, C79000-G8976-C270-06
CH1 is set to this mode when S0 is in position 0.
CH1 is set to this mode when S0 is in position 1.
Operator control (hardware)
4.2 Setting the operating mode
23