Replacing The Light Engine - Christie HS 2K Series Service Manual

4. To remove the white slicone and rubber on the sealing cover, use the side cutters carefully.
5. To disassemble the sealing cover, remove four M3 screws with a Phillips #1 screwdriver.
6. To release the color wheel module, remove the three M3 screws with a Phillips #1 screwdriver.
7. Replace the color wheel.
8. To re-install, follow these steps in reverse order.

Replacing the light engine

Replacing the light engine must be done in a clean room.
To remove the light engine, complete the following steps.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board module.
See Replacing the main board
HS Series 2K Service Manual—DWU1612-HS, DWU2022-HS
020-001790-01 Rev. 1 (03-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
on page 59.
on page 94.
Optics
85