b. Remove the lens through the front of the projector.
4. Install the new lens.
a. Fully insert the lens assembly straight into the lens mount
b. To lock the lens in place, rotate the lens clockwise
Replacing the complete engine
To re
ove the complete engine
m
1. Remove all covers from the projector.
See
Removing the top cover
front cover
on page 65,
side cover
on page 66.
2. Remove the main board and I/O board.
See
Replacing the main board and I/O board
3. Remove fans 5, and 7.
See
Replacing fans 5 and 7
4. To disassemble the dust protected cover, loosen the four captive screws with a Phillips #1
screwdriver.
5. Remove the thermal switch.
See
Removing the thermal switch
GS Series 1075 Service Manual
020-001236-02 Rev. 1 (12-2019)
complete the following steps.
,
on page 63,
Removing the rear cover
Removing the right-side cover
on page 70.
on page 76.
without turning.
A
.
B
on page 64,
on page 65, and
on page 83.
Optics
Removing the
Removing the left-
80