b. Remove the lens through the front of the projector.
4. Install the new lens.
a. Fully insert the lens assembly straight into the lens mount
b. To lock the lens in place, rotate the lens clockwise
Replacing the complete light engine
To remove the complete light engine, complete the following steps.
1. Remove the top covers from the projector.
See
Removing the top cover
2. Remove the main board and I/O board.
See
Replacing the main board and I/O board
3. Remove the rear cover.
See
Removing the rear cover
4. Remove the connector board.
See
Replacing the connector board
5. Remove fans 4, and 5.
See
Replacing fans 4 and 5
6. Remove the left-side cover.
See
Removing the left-side cover
7. Remove the thermal switch.
See
Removing the thermal switch
GS Series 630-635 Service Manual
020-001224-02 Rev. 1 (08-2018)
on page 51.
on page 69.
on page 52.
on page 74.
on page 58.
on page 53.
on page 60.
without turning.
A
.
B
Optics
66