Replacing The Light Engine - Christie DHD410S Service Manual

5. To disassemble the sealing cover, remove three M3 screws with a Phillips #1 screwdriver.
6. To release the color wheel module, remove the three M3 screws with a Phillips #1 screwdriver.
7. Replace the color wheel.
8. To re-install, follow these steps in reverse order.

Replacing the light engine

Replacing the light engine must be done in a clean room.
To remove the light engine, complete the following steps.
1. Remove the top cover.
See
Removing the top cover
2. Remove the main board.
DHD410S Service Manual
020-001481-01 Rev. 1 (10-2018)
on page 46.
Optics
62