Replacing The Light Engine - Christie CP2208 Service Manual

4. Remove the lamp. See
5. Remove the reflector assembly. See
6. Remove the top two screws and the attached clamps from the UV filter housing.
A
B
7. Slowly loosen the bottom screw until you can remove the UV filter.
8. To reinstall the UV filter, perform the steps in reverse order. Make sure that the filter is installed
with the arrow indicator on the edge of the filter pointing towards the lamp.

Replacing the light engine

Caution! Failure to comply with the following could result in minor or moderate injury.
Wear gloves and an electro-static bracelet when working with the light engine.
The light engine can be removed as an assembly with the harnesses still attached. Removing the
light engine this way reduces the risk of damage to other projector components.
1. Turn the projector off and then disconnect it from AC power.
2. Remove the lens. See
3. Remove the top lid. See
4. Remove the high security lid. See
CP2208 Service Manual
020-101917-01 Rev. 1 (11-2015)
Removing the existing lamp
Removing the reflector assembly
Top screws
A
Bottom screw
B
Removing the lens on page 44.
Removing the top lid
Removing the high security and light engine lid
Parts and Module Replacement
on page 40.
on page 33.
on page 48.
on page 35.
49