One-Shot Pulse Output Operation - NEC 78K0/KD1 Series User Manual

6.4.6 One-shot pulse output operation

16-bit timer/event counter 00 can output a one-shot pulse in synchronization with a software trigger or an external
trigger (TI000 pin input).
(1) One-shot pulse output with software trigger
A one-shot pulse can be output from the TO00 pin by setting 16-bit timer mode control register 00 (TMC00),
capture/compare control register 00 (CRC00), and 16-bit timer output control register 00 (TOC00) as shown in
Figure 6-27, and by setting bit 6 (OSPT00) of the TOC00 register to 1 by software.
By setting the OSPT00 bit to 1, 16-bit timer/event counter 00 is cleared and started, and its output becomes
active at the count value (N) set in advance to 16-bit timer capture/compare register 010 (CR010). After that, the
output becomes inactive at the count value (M) set in advance to 16-bit timer capture/compare register 000
Note
(CR000) .
Even after the one-shot pulse has been output, the TM00 register continues its operation. To stop the TM00
register, the TMC003 and TMC002 bits of the TMC00 register must be set to 00.
Note The case where N < M is described here. When N > M, the output becomes active with the CR000
register and inactive with the CR010 register.
Cautions 1. Do not set the OSPT00 bit to 1 while the one-shot pulse is being output. To output the one-
shot pulse again, wait until the current one-shot pulse output is completed.
2. When using the one-shot pulse output of 16-bit timer/event counter 00 with a software
trigger, do not change the level of the TI000 pin or its alternate-function port pin.
Because the external trigger is valid even in this case, the timer is cleared and started even
at the level of the TI000 pin or its alternate-function port pin, resulting in the output of a
pulse at an undesired timing.
CHAPTER 6 16-BIT TIMER/EVENT COUNTER 00
Preliminary User's Manual U16315EJ1V0UD
153