Chapter 27 Electrical Specifications (Target Values) - NEC 78K0/KD1 Series User Manual

CHAPTER 27 ELECTRICAL SPECIFICATIONS (TARGET VALUES)

These specifications are only target values, and may not be satisfied by mass-produced products.
The electrical specifications (target values) of (A1) products are under evaluation.
Absolute Maximum Ratings (T
Parameter
Supply voltage
Input voltage
Output voltage
Analog input voltage
Output current, high
(Refer to Note on the next page.)
Caution Product quality may suffer if the absolute maximum rating is exceeded even momentarily for any
parameter. That is, the absolute maximum ratings are rated values at which the product is on the
verge of suffering physical damage, and therefore the product must be used under conditions that
ensure that the absolute maximum ratings are not exceeded.
Remark Unless specified otherwise, the characteristics of alternate-function pins are the same as those of port pins.
408
= 25° ° ° ° C) (1/2)
A
Symbol Conditions
V
DD
EV
DD
REGC
V
SS
EV
SS
AV
REF
AV
SS
µ PD78F0124 Note 2
V
PP
V P00 to P03, P10 to P17, P20 to P27, P30
I1
to P33, P60, P61, P70 to P77, P120,
P130, P140, X1, X2, XT1, XT2, RESET
V P62, N-ch open drain
I2
P63
On-chip pull-up resistor
V V in flash programming mode
I3 PP
( µ PD78F0124 only)
V
O
V
AN
I Per pin
OH
Total of P00 to P03, P10 to P14, P70 to
all pins P77
−60 mA P15 to P17, P30 to P33, P60 to
P63, P120, P130, P140
Preliminary User's Manual U16315EJ1V0UD
Ratings
−0.3 to +6.5
−0.3 to +6.5
−0.3 to +6.5
−0.3 to +0.3
−0.3 to +0.3
−0.3 to V
Note 1
+ 0.3
DD
−0.3 to +0.3
−0.3 to +10.5
−0.3 to V
Note 1
+ 0.3
DD
−0.3 to +13
−0.3 to V
Note 1
+ 0.3
DD
−0.3 to +10.5
−0.3 to V
Note 1
+ 0.3
DD
− 0.3 to AV
Note 1
AV + 0.3
SS REF
and −0.3 to V
Note 1
+ 0.3
DD
−10
−30
−30
Unit
V
V
V
V
V
V
V
V
V
V
V
V
V
V
mA
mA
mA