Pull the Head Shield to the front and remove it.
8
Fix the Head Board Cover temporarily, and remove the 2 Ink
9
Dampers from the Head that will be replaced.
Be sure to remove and fi x the Ink Damper with the
Head Board Cover fixed. It prevents the ink from
dropping on the Head Board.
If the ink drops on the Head Board, Head or Head
Driving IC will be damaged.
Remove the Ink Damper with pulling the upper end of
the Damper Shield when removing the Ink Damper.
Remove the Head Board Cover and disconnect the 2 fl exible
10
cables from the Head.
Make sure that LED on the Carriage Board is
turned off when disconnecting the fl exible cables.
Remove the spring, and remove the 3 screws fi xing the Head.
11
And then, pull the Head forward and pull it up to remove it.
Head Shield
Damper Shield
Head Board Cover
Head Board Cover
Flexible Cable
3-7
Spring