Roland VersaUV LEJ-640 Service Notes page 313

Setup of Media
- About [Media Setting] menu
- Setup of Media ([Media Setting] menu)
Outputting
- Setting the Output-start Location
- Printing Tests and Cleaning
- Getting Ready to Receive Data from a Computer
- Starting Output
- Pausing and Canceling Output
- Cutting Off the Media
If the printing-test results are dif cult to interpret, examine the results from different angles in a well-
lighted location. Take advantage of re ected light to enable visual checking. We recommend performing
the printing test on transparent or silver-colored media.
Switch Off
Media Take-up System
The Media Take-up System
Use Conditions of the Media Take-up System
- When Performing Output without Pullback Movement (or When [TU] Is Selected)
- When Performing Output Involving Pullback Movement (or When [TU2] Is Selected)
- Loading the Media onto the Media Take-up System
- Removing Taken-up Media
!! IMPORTANT !!
Avoid following operations that pull the media with undue force.
- Never operate the MANUAL switch when the loading lever is lowered.
- Never use
Job outputting from Roland
VersaWorks (Basic Operation)
Explain the printing procedure in reference to Roland VersaWorks Quick Start Guide section 2.
Printing
!! IMPORTANT !!
- Use the media clamps when using media that is less than 0.5 mm (0.02 inches) thick. Otherwise the
edges of the media may warp and catch on the print head.
- If you are using media that is less than 0.5 mm (0.02 inches) thick, do not use the media clamps if [HEAD
HEIGHT] is set to [LOW]. The media clamps may catch on the print heads, damaging the machine.
- During output, never touch the media. Doing so may obstruct media feed or cause the media to rub
against the heads, which may result in a paper jam or damage to the heads.
- Keep the loading lever raised when the machine is not in use.
to feed the media in reverse.
7-9