Press the [ENTER] key to cap the heads.
4
Carry out the Limit Position Initialize by pressing the
5
[ENTER] key again.
After the limit Position Initialize is completed, the mes-
sage appears as shown in the fi gure.
<CUTTER POSITION INITIALIZE>
Move the Tool Carriage with your hand until it makes
6
full contact with the left frame with Cut Down status.
Press the [ENTER] key to perform the Cut Down Posi-
7
tion Initialize.
After initialization is completed, the message as shown
in the fi gure is displayed.
MOVE TO CAP POS
[ ]
SETTING UP
DETECTING..
SETTING UP
CUTTER DOWN POS
SETTING UP
CUTTER DOWN POS
DETECTING..
INITIALIZATION
4-40
THE LIMIT
[ ]
[ ]
COMPLETED