Infeeds With Drive-Cliq Connection - Siemens SIMOTION D4x5-2 Commissioning And Hardware Installation Manual

Commissioning (software)
7.8 Activating the infeed (line module)
Figure 7-51
7.8.2

Infeeds with DRIVE-CLiQ connection

The infeed is controlled via DRIVE‑CLiQ. The infeed is switched on or off by the
SIMOTION D4x5‑2 via PROFIdrive message frame 370.
If "Use symbolic assignment" has been activated, message frame 370 is set automatically
when setting standard/automatic (see Section Calling the drive wizard (Page 176)).
With message frame 370, the required BICO interconnections to the message frame are
created automatically on the drive unit.
If an infeed with DRIVE‑CLiQ connection has already been created, the infeed signal "Closed-
loop control operation, r863.0" is automatically interconnected to "Infeed operation, p0864" of
the drive when drives are inserted (only applies to drives that are attached to the same drive
unit as the infeed).
268
Interconnection of the "Infeed in operation" signal
Commissioning and Hardware Installation Manual, 03/2018, A5E33441636B
SIMOTION D4x5-2