7.19
Powering down the system
If you wish to shut the system down, you must ensure that all axes and system parts are set
to a safe state. You can set this up by providing a separate motion task, for example.
Once the system is at a standstill, you can switch off the power supply.
Note
You must observe the safety notes for SINAMICS components, which you will find in the
corresponding SINAMICS manuals.
SIMOTION D4x5-2
Commissioning and Hardware Installation Manual, 03/2018, A5E33441636B
Commissioning (software)
7.19 Powering down the system
317