Power Supply; Safety Rules; Standards And Regulations - Siemens SIMOTION D4x5-2 Commissioning And Hardware Installation Manual

4.4

Power supply

4.4.1

Safety rules

Basic rules
Because of the wide range of possible applications, only the basic rules for electrical installation
are described in this section. At a minimum, you must comply with these basic rules to ensure
problem-free operation.
Rules for safe operation
In order to ensure safe operation of your equipment, implement the following measures,
adapting them to suit your conditions:
● An EMERGENCY STOP concept in accordance with the generally accepted rules of current
engineering practice (e.g. European standards EN 60204, EN 418, and similar).
● Additional measures for end position limiting of axes (e.g. hardware limit switches).
● Equipment and measures for protection of motors and power electronics in accordance
with the SINAMICS installation guidelines.
To identify hazards, we also recommend that a risk analysis be conducted on the entire
system in accordance with the basic safety requirements set out in Appendix 1 of the EU
Machinery Directive.
Additional references
● Guidelines on Handling Electrostatically Sensitive Devices (ESD), see Appendix.
● For installing a system with SIMATIC ET 200 I/O (e.g. ET 200SP, ET 200 MP, etc.), see the
manuals for the relevant ET 200 I/O systems.
● As a further source of information on EMC, we recommend the
Basic System Requirements Configuration Manual, article number 6FC5297‑0AD30‑0AP3.
Download: (https://support.industry.siemens.com/cs/ww/en/view/60612658)
4.4.2

Standards and regulations

VDE guideline compliance
During wiring, you must observe the appropriate VDE guidelines, in particular VDE 0100 and
VDE 0113 for tripping devices and short-circuit and overload protection.
System startup after certain events:
SIMOTION D4x5-2
Commissioning and Hardware Installation Manual, 03/2018, A5E33441636B
Connecting
4.4 Power supply
EMC Installation Guidelines /
63