New Holland CX720 Repair Manual page 2184

B. If there is no continuity to ground, continue with step 6.
6. The voltage reading on the InfoView monitor is low (<0.3 volts). Use a multimeter to check for continuity be-
tween the main frame harness end of connector X010 pin 8 and chassis ground.
A. If there is continuity to ground, there is a short to ground in the main frame (MF) harness between con-
nector X010 pin 8 and connector X016 pin J2-29 wire 420 yellow. Locate the short and repair.
B. If there is no continuity, continue with step 7.
7. Carefully disconnect the main frame harness from the CCM2 module at connector X016. Install a jumper wire
between the harness end of connector X016 pin J2-29 and chassis ground. Use a multimeter to check for
continuity between connector X202 pin 2 and chassis ground, and between connector X330 pin A and chassis
ground.
A. If continuity is found from both connectors, continue with step 9.
B. If no continuity is found, continue with step 8.
8. Disconnect the engine harness from the main frame harness at connector X010. Use a multimeter to check for
continuity between the harness end of connector X010 pin 8 and chassis ground.
A. If there is continuity, there is an open circuit in the engine (EN) harness between connector X010 pin 8,
connector X330 pin A and connector X202 pin 2 wire 420 yellow, 860 yellow or 864 yellow. Locate the
open and repair.
B. If there is no continuity to ground, there is an open circuit in the main frame (MF) harness between con-
nector X010 pin 8 and connector X016 pin J2-29 wire 420 yellow. Locate the open and repair.
9. Operate the machine while monitoring InfoView display.
A. If no high out of range readings are indicated, erase the fault code and continue operation.
POWER PRODUCTION - AIR INTAKE SYSTEM
2 4/7/2006
B.30.A / 50