New Holland CX720 Repair Manual page 2598

10. Check the roll torque of the hydraulic pump drive for
compliance with the nominal value of 300 - 400 Nmm
(2-3 in. lbs.).
11. If necessary, the shim thickness must be adjusted
to reach the nominal value of 300 - 400 Nmm (2-3
in. lbs.).
12. Turn the housing over and support it with the opening
for the engine flange pointing in the upward direction.
Install the inner bearing race and the previously re-
moved shim pack at (1), if it had been removed.
POWER TRAIN - PROCESS DRIVE Primary process drive
2 4/7/2006
C.50.B / 34
10
10012216
11
10012217
12
10012219