New Holland CX720 Repair Manual page 1764

12. Using a feeler gauge (2) check the opening between
the ends of the ring seals (1) inserted in the cylinder
liner (3).
On finding a higher or lower distance between the
ends than as required, replace the piston rings.
13. CHECKS, MEASUREMENTS AND REPAIRS ON
THE CONNECTING RODS
Clean the parts thoroughly before doing any work.
F2B Engine - Main data for the connecting rod, bush-
ing, pin and half bearings (Dimensions in mm)
* Dimension to be obtained after driving home the
bushing.
Handle all parts carefully. Do not put your hands or fin-
gers between parts. Always wear suitable safety items
such as fitted clothing, safety goggles, gloves, shoes,
etc. M954
14. F3A Engine - Main data for the connecting rod, bush-
ing, pin and half bearings (Dimensions in mm)
* Dimension to be obtained after driving home the
bushing.
The data for the classes of selection for the big-end
bearing seat and weights are punched on the big end
of the connecting rod.
Outline of connecting-rod punch-marks
NOTE: When fitting the connecting rods, check they are all
of the same class.
POWER PRODUCTION - ENGINE
CAUTION
Letter specifying class of weight:
15
MID0431A
2 4/7/2006
B.10.A / 218
13
MID0429A
14
MID0430A