Outline for fitting the connecting rod-piston assembly in the cylinder liner
1 Connecting rod-piston assembly.
3 Connecting rod punching zone.
4.
Connect the connecting rods to the relevant pins of
the crankshaft. Fit on the caps of the connecting rod
(1) together with the half bearings.
Screw down the fixing screws (2) and tighten them in
two stages to the torques given in the following table:
1st phase
50 Nm (5 kgm [37 ft. lbs.])
2nd phase, angle 40 °
POWER PRODUCTION - ENGINE
4
MID0333A
2 Punched zone on the top of the piston with symbol for
the assembly position and class of selection.
5
MID0334A
F2B
2 4/7/2006
B.10.A / 208
F3A
60 Nm (6 kgm [44 ft. lbs.])
60 °