New Holland CX720 Repair Manual page 2582

19. Disconnect and cap hydraulic line (1) from the main
hydrostatic pump. Turn four cap screws out from
each fitting (2) to disconnect the hydraulic lines from
the pump. Cap the lines just removed.
Disconnect and cap hydraulic line (3) from the main
hydrostatic pump.
NOTE: When disconnecting hydraulic lines, have a suit-
able container readily available to capture any residual hy-
draulic oil.
20. Disconnect and cap hydraulic line (1) from the main
hydrostatic pump. Detach the connector (2) from the
oil pressure switch. Unplug the connector(3), from
the Electronic Displacement Control (EDC) Valve.
21. Disconnect and cap hydraulic line (1) at both ends
and remove from the combine. Store the line in a
suitable location.
Turn off oil filter (2).
Loosen but do not remove the four hydrostatic pump
mounting cap screws (3).
POWER TRAIN - PROCESS DRIVE Primary process drive
2 4/7/2006
C.50.B / 18
19
10012187
20
10012188
21
10012189