New Holland CX720 Repair Manual page 1713

Crankshaft - Assemble (B.10.A.43 - F.10.A.20)
CX860, CX880
NOTE: On finding there is no need to replace the crankshaft bearings, it is necessary to fit them back on in the
same sequence and position found during disassembly. If you need to replace them, select the crankshaft bearings
according to the selection described on Crankshaft - Repair (B.10.A.43 - F.10.A.32).
Do not make any adjustments to the bearings. Z106
1. Fitting the crankshaft bearings
If dismantled, refit the oil nozzles (2) tightening the
union (3) to the required torque.
Put the half bearings (1) on the crankshaft mounts of
the crankcase.
The crankshaft bearings are supplied as spare parts
with an undersized internal diameter of 0.127 —
0.254 — 0.508 mm (.005 - .010 - .020 in).
2. Using a hoist and hook 293273 (1), mount the crank-
shaft (2).
3. Put the half bearings (1) on the main bearings in the
sub-crankcase,(2).
POWER PRODUCTION - ENGINE
CAUTION
2 4/7/2006
B.10.A / 167
1
MID0316A
2
MID0317A
3
MID0318A