10.
Remove the drive housing (1) from the gearbox.
11.
Lift the hydrostat drive from the gearbox.
Turn the gearbox over and support it with the engine
flange/input shaft pointing in the upward direction.
12.
Remove cap screws (1) holding the engine flange
onto the gearbox.
Separate the engine flange (2) from the gearbox.
NOTE: When removing the engine flange, protect the shaft
seal against damage from the multi-spline profile of the
spur gear shaft.
POWER TRAIN - PROCESS DRIVE Primary process drive
2 4/7/2006
C.50.B / 8
10
10002713
11
10004286
12
10004290