Motor - Remove (C.20.F.28 - F.10.A.10)
1.
Drive Motor Removal
Drain the hydraulic reservoir.
Remove the two main hydraulic lines (1) by turning
out eight cap screws.
NOTE: During removal of the three hydraulic lines, up to
five additional gallons of fluid can be expected. A suitable
container must be positioned under the lines to capture the
residual hydraulic fluid.
2.
Unplug electrical connector (1) Turn out the screw
from the top of electrical connector (2). Unplug elec-
trical connector (2) from the solenoid.
3.
Disconnect the case drain line (1) at the upper elbow
union. Loosen the lower elbow union (2) and rotate
the elbow 90 degrees .
POWER TRAIN - TRANSMISSION Hydrostatic
2 4/7/2006
C.20.F / 78
1
10013278
2
10013279
3
10013280