New Holland CX720 Repair Manual page 2593

22. Shut or verify shut the engine gearbox and hydraulic
reservoir drain line connections.
Fill the engine gearbox with 11 L (11.6 qts ) of hy-
draulic oil.
Fill the hydraulic reservoir with 60 L (16 gal) of hy-
draulic oil.
Start the engine and allow the oil level in the gear-
box to stabilize. Fill the gearbox as necessary with
hydraulic oil to maintain the level in the sight glass,
but below the red full mark.
23. If the unloading auger is attached to the operating
cylinder, rotate the auger into its standby position.
If the cylinder has been disconnected from the auger,
carefully rotate the auger into its standby position.
Attach the cylinder to the hinge point on the auger.
Tighten or verify tight the hydraulic lines to the un-
loading auger cylinder.
24. Attach the appropriate lifting equipment to the com-
bine door hinges and set the door into place. Insert
the hinge pins and secure them in place using cotter
pins.
NOTE: The weight of the combine door is approximately
68 kg (150 lbs).
NOTE: The door is heavy and awkward. Improper handling
of the door during installation could cause serious injury.
POWER TRAIN - PROCESS DRIVE Primary process drive
2 4/7/2006
C.50.B / 29
22
50012171_901
23
40012179_902
24
10012176