New Holland CX720 Repair Manual page 1751

Connecting rod and piston - Remove (B.10.A.47 - F.10.A.10)
CX720, CX740, CX760, CX780, CX820, CX840
NOTE: The pistons, crankshaft and cylinder block can only be serviced with the engine removed from the vehicle.
1. Removal
2. Remove the oil pan.
With cylinder head removed clean off any ridge from
the top of the cylinder bores, with a ridge remover to
enable removal of the pistons, this is essential if old
pistons are to be re-used as failure to do so could
result in ring land damage.
3. With the piston at the bottom of the stroke remove
the end cap bolts, cap, and liner.
4. Using the handle end of a hammer push the pis-
ton assembly out through the top of the block, and
remove the bearing liner from the connecting rod,
Fig.2.
Turn the crankshaft again and repeat the process for
the remaining pistons.
NOTE: Bearing caps and liners must be kept with their re-
spective connecting rods.
POWER PRODUCTION - ENGINE
2 4/7/2006
B.10.A / 205
1
BSD1853A
2
TA6010033
3
BSD1850A_772