New Holland CX720 Repair Manual page 2612

8. Attach a puller to the clutch assembly as shown.
9. Remove the assembly along with the tapered bear-
ing (1) and spacer ring (2).
Place the multi-disk clutch assembly on a sturdy
working surface with the piston side up.
10. Remove only four of the cap screws. Leave two cap
screws installed(1), 180 ° apart.
NOTE: Do not, under any circumstances, loosen all fas-
tening screws of the multi-disk clutch. The pressure plate
is under very high spring pressure. Improper disassembly
of the multi-disk clutch will cause severe personal injury.
11. Turn two M8 x 30 mm cap screws with washers (2)
into the assembly to be used as jacking bolts.
Remove the remaining Allen head cap screws.
Loosen the jacking bolts evenly allowing the inter-
nal springs to push the piston from the assembly.
Tension on the jacking bolts will slacken when the
springs have been fully expanded.
POWER TRAIN - PROCESS DRIVE Primary process drive
2 4/7/2006
C.50.B / 48
7
10004296
8
10004297
9
10004298