Rep 8.15 Cutter Home Sensor - Xerox 8825 Service Manual

REP 8.15 Cutter Home Sensor

Parts List on PL 7.8
Switch off the Main Power Switch. Disconnect the Power Cord.
NOTE: The art used for this procedure was developed for previous products and may not
match the 8825/8830 configuration exactly.
Removal
1. Open the Cutter Drawer.
2. (Figure 1): Remove the Cutter Home Sensor.
8825/8830 Printer
WARNING
2
Squeeze the tabs
Figure 1 Removing the Cutter Home Sensor
Replacement
1. Center the Disc of the Cutter Drive Pulley in the sensor during reassembly.
01/02
4-39
3
Rotate the sensor
and remove it
Cutter
Drive
Pulley
1
Disconnect the connector
Repairs and Adjustments
REP 8.15