Codec Tieline ViA User Manual page 342

342 ViA User Manual v3
1. Click to select the check-box for Create a Failover Connection. Adjust the parameters
and click Next.
Important Note: When Failover is enabled, the codec will fail over to a backup
connection under the following circumstances:
· There is sudden loss of connectivity to the primary destination.
· The remote codec disconnects the primary connection.
· The user manually attempts to connect to the failover connection.
· When the conditions for failover are triggered by the Failover Parameters.
The codec will always attempt Failback if any of the following conditions are met:
· There is sudden loss of connectivity to the backup destination.
· The remote codec disconnects the backup connection.
· The user manually attempts to connect to the primary connection.
The explanations within the following table can be used to assist with failover connection
configuration.
Screen Display
1 Threshold
2 Time Frame
3 Keep Alive
4 Enable Automatic Failback
5 Stable Time
6 Maximum Retries
7 Time Frame
2. Enter a name for the backup connection and click Next.
Description
The percentage of lost data measured during a given time
frame
The time frame against which lost data is measured
The keep connection alive time before failing over to a
backup connection; Tieline RTP pings every second to
confirm connectivity
Select the check-box to fail back to a higher priority
connection when failback parameters are met
The amount of time a primary connection must remain
stable before attempting to fail back from the backup
connection
The maximum number of fail back retries a codec can try
before ending fail back attempts
The time frame used to measure the number of fail back
retries attempted
© Tieline Research Pty. Ltd. 2020