Codec Tieline ViA User Manual page 304

304 ViA User Manual v3
Configuring a Failover Connection or Auto Reconnect
At this point in the wizard you can choose to configure Auto Reconnect or create a failover
connection for the audio stream you are configuring.
Important Note: When Auto Reconnect is enabled, the dialing codec will continue to
attempt a connection with the remote codec until Disconnect is pressed either on the
dialing codec's keypad, or in the Web-GUI.
1. Click to select the check-box for Create a Failover Connection. Adjust the parameters
and click Next.
Important Note: When Failover is enabled, the codec will fail over to a backup
connection under the following circumstances:
· There is sudden loss of connectivity to the primary destination.
· The remote codec disconnects the primary connection.
· The user manually attempts to connect to the failover connection.
· When the conditions for failover are triggered by the Failover Parameters.
The codec will always attempt Failback if any of the following conditions are met:
· There is sudden loss of connectivity to the backup destination.
· The remote codec disconnects the backup connection.
· The user manually attempts to connect to the primary connection.
The explanations within the following table can be used to assist with failover connection
configuration.
Screen Display
1 Threshold
2 Time Frame
3 Keep Alive
4 Enable Automatic Failback
Description
The percentage of lost data measured during a given time
frame
The time frame against which lost data is measured
The keep connection alive time before failing over to a
backup connection; Tieline RTP pings every second to
confirm connectivity
Select the check-box to fail back to a higher priority
connection when failback parameters are met
© Tieline Research Pty. Ltd. 2020