Codec Tieline ViA User Manual page 311

7. Configure destination codec dialing and encoding settings. Enter an IP address, or click the
Address Book
For IP connections configure the IP address, ports, and then specify which streaming
interface is used to dial this connection, e.g. Primary (port LAN1) or Secondary (port
LAN2). Note: By default Any will select LAN1 if it is available and LAN2 if it is unavailable.
If TieLink Contact List dialing is configured:
1. Click the Address Book
2. Select the interface options to use on local and remote codecs when dialing TieLink
© Tieline Research Pty. Ltd. 2020
button to select a TieLink contact.
Important Note: The Remote Audio Port is the codec port at the remote end of
the link to which you are sending audio. The Local Audio Port is used by the local
codec to receive audio from the remote codec. When Tieline Codecs is the
Session Protocol selected (using Tieline session data), the default port value for the
Local Audio Port is Automatic. Note: Automatic indicates that the codec will
arbitrarily allocate the local port value and send this information to the codec to
which you are dialing. Click to deselect the Automatic check-box and change this
setting. When you select Sessionless as the Session Protocol, the Session Port
is not configurable and you can manually configure the Remote Audio Port and
Local Audio Port.
Address Book.
connections. Note: see
button to select a contact to dial from the TieLink
Configuring TieLink Settings
ViA User Manual v3
for more info.
311