Codec Tieline ViA User Manual page 269

Important Note: Ensure an answering program is configured for Fuse-IP on the
destination codec and locked.
© Tieline Research Pty. Ltd. 2020
iii. Discrete recurring: Uses the first interface that is not being used by another
connection (within the same audio stream). After all interfaces have been used,
each audio stream will scan each interface from the start again, in the order in
which they are listed, and connect using the first available interface that will
successfully dial and connect. The dialing order of the interfaces in the TieLink
panel can be adjusted by clicking a dragging interfaces on the left side of the
panel when it is in Edit mode.
iv. Fuse-IP: Connect using Fuse-IP data bonding. Multiple interfaces can be selected
and bonded to aggregate data and create a higher bandwidth connection. This is
configured in the TieLink panel as displayed in the following example. Please
note that this is the simplest way to configure a Fuse-IP connection.
ViA User Manual v3 269