Drive-Cliq Signal Cables Motion-Connect With Drive-Cliq Connectors; Motion-Connect Drive-Cliq Signal Cables With Drive-Cliq Connector And M12; Socket - Siemens SINAMICS S120 Equipment Manual

Cabinet design and EMC for components, Blocksize format
11.6 Connection Methods
DRIVE-CLiQ bridge
300 mm
350 mm
Cable length without connector
1)
Cable lengths from 600 mm and higher are used to connect to other applications (e.g.
establish a 2nd line in the drive line-up, establish wiring in a star configuration etc. )
Figure 11-2
11.6.1.3

DRIVE-CLiQ signal cables MOTION-CONNECT with DRIVE-CLiQ connectors

The MOTION-CONNECT DRIVE-CLiQ signal cables with DRIVE-CLiQ connectors have 24
V DC cores. They are used for components with DRIVE-CLiQ connection if higher
requirements must be complied with, such as mechanical stress and resistance to oil. For
example, the signal cables are used for connections outside the control cabinet
The maximum length of the DRIVE-CLiQ MOTION-CONNECT signal cables with DRIVE-
CLiQ connectors is:
● 100 m for MOTION-CONNECT 500 cables
● 75 m for MOTION-CONNECT 800PLUS cables
The signal cables are available in degrees of protection IP20 and IP67.
Note
DRIVE-CLiQ cabinet bushing for DRIVE-CLiQ connectors
For information about the cabinet bushing, see DRIVE-CLiQ cabinet bushings (Page 349).
11.6.1.4

MOTION-CONNECT DRIVE-CLiQ signal cables with DRIVE-CLiQ connector and M12

socket

The MOTION-CONNECT DRIVE-CLiQ signal cables with DRIVE-CLiQ connector and M12
socket have 24 V DC cores. They establish the connection between components with a
DRIVE-CLiQ connection and a direct measuring system equipped with DRIVE-CLiQ ASIC
with 8-pin M12 connector. Measuring systems from third-party manufacturers can be directly
connected to the SINAMICS S120.
378
DRIVE-CLiQ signal cables without 24 V DC cores (IP20)
Cable length L
1)
360 mm
410 mm
Manual, 06/2019, 6SL3097-5AL00-0BP1
AC Drive